He has described the pen lid method, which will automatically clean your toilet with every flush. In this method, just a pen lid lying unused in the house, baking soda and detergent is used. In this trick, along with less effort, the cost is also less.
preparing cleaning solution
First of all, take an old utensil which is not used in the kitchen. Add one spoon baking soda and one spoon detergent powder in it. After this, prepare a thick paste by adding some toilet cleaner to it. The mixture of these three things will be useful in eliminating the yellowness and germs of the toilet. You can use an old wooden spoon to make the mixture so that your hands do not get harmed.
Smart use of pen cap
Now fill this thick paste in the lid of a pen. Here the lid of the pen will work like a slow release fertilizer, which will slowly release the cleaning solution into the water. With the help of a wooden spoon, fill the lid well till the top. You will not need to touch the paste with your hands during this entire process.
polythene coating
After filling the mixture in the lid, it is important to secure it so that it does not flow together into water. For this, take a small piece of old vegetable polythene and cover the open part of the lid with it. Now tie the polythene firmly with the help of a thread. The extra polythene left on the outside should be cut off with scissors so that it does not get stuck in the machinery of the flush tank.
fine holes for water flow
Now take a thin pin or needle and make 4-5 small holes on the polythene. These holes are very important because through them the water from the flush tank will enter inside the lid and slowly dissolve the cleaning mixture and take it out. If the holes are too big, the mixture will run out quickly, so keep the holes very fine.
hanging technique in flush tank
Now tie a long thread at the back of the lid. Keep this thread so long that when the lid is inserted inside the flush tank of the toilet, the other end of the thread hangs outside. Hang the lid inside the water and press the thread on the edge while closing the lid of the tank.
how to clean toilet
Automatic cleaning with every flush
Now your work is finished. Whenever you press the flush button of the toilet, a mixed solution of baking soda, detergent and cleaner will come out along with the water in the tank. This solution will clean the dirt from the toilet pot, remove the yellowness and also eliminate the bad smell. You will not have to do the hard work of scrubbing with a brush again and again and the toilet will remain fresh and clean all the time.
Disclaimer: The claims made in this article are based on YouTube videos and information found on the internet. NBT does not take responsibility for its truthfulness and accuracy.
